Troubleshooting - Panasonic LUMIX H-FS1442A Bedienungsanleitung

VQT4N34_ENG.fm 9 ページ ２０１３年１月２１日 月曜日 午後１時５５分
– In direct sunlight or on a beach in summer
– In locations with high temperatures and humidity
levels or where the changes in temperature and
humidity are acute
– In locations with high concentrations of sand,
dust or dirt
– Where there is fire
– Near heaters, air conditioners or humidifiers
– Where water may make the unit wet
– Where there is vibration
– Inside a vehicle
≥ Refer also to the operating instructions of the
digital camera.
≥ When the unit is not going to be used for a
prolonged period, we recommend storing with a
desiccant (silica gel). Failure to do so may result in
performance failure caused by mold, etc. It is
recommended that you check the unit's operation
prior to use.
≥ Do not leave the lens in contact with rubber or
plastic products for extended periods of time.
≥ Do not touch the lens contact point. Doing so can
Downloaded from www.Manualslib.com manuals search engine
≥ Use a dry, dust cloth to remove dirt and dust on
the zoom ring and the focus ring.
≥ Do not use a household detergent or a chemically
treated cloth.

Troubleshooting

A sound is heard when the camera is turned on
or off.
≥ This is the sound of lens or aperture movement
and is not a malfunction.
When this lens is attached to digital camera,
stabiliser function cannot be turned off or
stabiliser function does not work.
≥ The Optical Image Stabiliser function of this lens
only works correctly with supported cameras.
> When older Panasonic digital cameras (DMC-GF1,
DMC-GH1, DMC-G1) are used, [Stabilizer] in the
[Rec] mode menu cannot be set to [OFF]. It is
recommended to update the firmware of the digital