Advice For Use; Device Maintenance - VISIOMED BABY MX6-ONE Gebrauchsanleitung

to suck all the saline solution so that this does not go down to the bronchi.
Do not keep the saline solution for more than 24hrs in the sterile bottles
because of high and rapid risk of bacterial contamination.

ADVICE FOR USE :

- During suction, make sure the baby's mouth is open to ensure the pressure
on the inner ear is released.
- Suction duration : 8 seconds per nostril.
- Make sure not to suck the nose wall.
- Do not push the end piece in baby's nostril.
- This movement should not be sudden, avoid excessive pressure that can
harm the ear and sinus.
Repeat as many times as necessary to unclog the nose.
Change hygienic caps as needed.
- Regular instillations of sterilized seawater or physiological saline solution–
they properties are rather similar – help liquefy secretions and unclog the
nose. Make sure the saline solution is at room temperature. The instillation
should be practiced with the head on the side, in lying position. Never
perform an instillation with the head back.
- When using a saline solution (such as seawater, physiological saline so-
lution...), a large amount of liquid mixed with the secretions may fall in
the bronchia. Make sure that liquid mixture is fully removed using the
BABYDoo MX6-One.
®
IT IS ADVISED TO CONSULT YOUR DOCTOR :
WHEN IN DOUBT ABOUT YOUR CHILD'S HEALTH
WHEN IN DOUBT AS TO THE USE OF THIS DEVICE
- After each use, throw the hygienic caps. Clean the device with soapy
water.
- Do not immerse the whole of device in any liquid.
- Sterilize the BABYDoo MX6-One once a day in case of regular use.
®
- Do not sterilize the battery compartment.
- Do not sterilize the accessories in a microwave.
- Do not keep the saline solution in the sterile bottles for more than 24hrs,
because of the high and rapid risk of bacterial contamination.
18 Visiomed BABYDOO MX6-ONE - V6 - 012017
TROUBLE SHOOTING
If one of the following problems arises when using your baby nose cleaner
BABYDoo MX6-One, refer to this trouble shooting guide. If the problem
®
persists, please contact our customer support at +33 892 350 334.
Problem
No suction
Water leak or accumulation
in the cover
Nothing happens when you press
the switch button

DEVICE MAINTENANCE

- Clean BABYDoo MX6-One with soapy water.
®
- You can cold sterilize the removable section of the BABYDoo
as well as the accessories (probes and joints).
- Do not sterilize the accessories in a microwave.
- Use a dry and soft cloth to clean the main unit. If necessary, use a damp
cloth.
- Never use alcohol, benzene, thinners or other chemicals to clean the
device.
- A void placing the unit in direct sunrays, high humidity or dust.
Note: If the device is not used for an extended period, make sure the bat-
teries are removed (they could damage the device).
Visiomed BABYDOO MX6-ONE - V6 - 012017
Solution
- Check the sealing joint
(position, wear...)
- Check the sealing of the device: the
4 notches of the cover and the main
unit must face each other.
- Check the position of the cover.
- Check the position of the silicone
probe.
- Check that the air inlet is not
blocked.
- Check the sealing of the device :
the 4 notches of the cover and the
main unit must face each other.
- Check the cover is not upside-down.
Check the batteries (polarity, wear...)
MX6-One,
®
.
19