Trouble Shooting Chart - World Dryer Warm Air DXA Betriebsanweisung Und Teile-Handbuch

World Dryer Operating Instructions and Parts Manual
World Dryer
E
N
G
Troubleshooting Chart
L
Symptom
I
Dryer fails to start
S
H
A glow is seen through
nozzle but no air is blowing
Dryer blows cold air
Automatic model dryer
will not shut off
LIMITED WARRANTY
WORLD TEN-YEAR LIMITED WARRANTY. WORLD DRYER
WORLD DRYER CORP. TO THE ORIGINAL USER AGAINST DEFECTS IN WORKMANSHIP OR MATERIALS UNDER NORMAL USE FOR TEN YEARS AFTER
DATE OF PURCHASE. ANY PART WHICH IS DETERMINED TO BE DEFECTIVE IN MATERIAL OR WORKMANSHIP AND RETURNED, SHIPPING COSTS PREPAID,
WILL BE, AS THE EXCLUSIVE REMEDY, REPAIRED OR REPLACED AT WORLD'S OPTION. FOR LIMITED WARRANTY CLAIM PROCEDURES, SEE "PROMPT
DISPOSITION" BELOW. THIS LIMITED WARRANTY GIVES PURCHASERS SPECIFIC LEGAL RIGHTS WHICH VARY FROM JURISDICTION TO JURISDICTION.
LIMITATION OF LIABILITY. TO THE EXTENT ALLOWABLE UNDER APPLICABLE LAW, WORLD'S LIABILITY FOR CONSEQUENTIAL AND INCIDENTAL
DAMAGES IS EXPRESSLY DISCLAIMED. WORLD'S LIABILITY IN ALL EVENTS IS LIMITED TO AND SHALL NOT EXCEED THE PURCHASE PRICE PAID.
WARRANTY DISCLAIMER. A DILIGENT EFFORT HAS BEEN MADE TO PROVIDE PRODUCT INFORMATION AND ILLUSTRATE THE PRODUCTS IN THIS
LITERATURE ACCURATELY; HOWEVER, SUCH INFORMATION AND ILLUSTRATIONS ARE FOR THE SOLE PURPOSE OF IDENTIFICATION, AND DO NOT
EXPRESS OR IMPLY A WARRANTY THAT THE PRODUCTS ARE MERCHANTABLE, OR FIT FOR A PARTICULAR PURPOSE, OR THAT THE PRODUCTS WILL
NECESSARILY CONFORM TO THE ILLUSTRATIONS OR DESCRIPTIONS. EXCEPT AS PROVIDED BELOW, NO WARRANTY OR AFFIRMATION OF FACT,
EXPRESSED OR IMPLIED, OTHER THAN AS STATED IN THE "LIMITED WARRANTY" ABOVE IS MADE OR AUTHORIZED BY WORLD.
Technical Advice and Recommendations, Disclaimer. Notwithstanding any past practice or dealings or trade custom, sales shall not include
the furnishing of technical advice or assistance or system design. World assumes no obligations or liability on account of any unauthorized
recommendations, opinions or advice as to the choice, installation or use of products.
Product Suitability. Many jurisdictions have codes and regulations governing sales, construction, installation, and/or use of products for certain
purposes, which may vary from those in neighboring areas. While attempts are made to assure that World products comply with such codes, World
cannot guarantee compliance, and cannot be responsible for how the product is installed or used. Before purchase and use of a product, review the
product applications, and all applicable national and local codes and regulations, and be sure that the product, installation, and use will comply
with them.
Certain aspects of disclaimers are not applicable to consumer products; e.g., (a) some jurisdictions do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitation or exclusion may not apply to you; (b) also, some jurisdictions do not allow a limitation on how
long an implied warranty lasts, consequently the above limitation may not apply to you; and (c) by law, during the period of this Limited Warranty,
any implied warranties of implied merchantability or fitness for a particular purpose applicable to consumer products purchased by consumers,
may not be excluded or otherwise disclaimed.
Prompt Disposition. A good faith effort will be made for prompt correction or other adjustment with respect to any product which proves to be
defective within limited warranty. For any product believed to be defective within limited warranty, first write or call dealer from whom the product
was purchased. Dealer will give additional directions. If unable to resolve satisfactorily, write to World at address below, giving dealer's name, address,
date, and number of dealer's invoice, and describing the nature of the defect. Title and risk of loss pass to buyer on delivery to common carrier.
If product was damaged in transit to you, file claim with carrier.
Manufactured by World Dryer Corp.
Berkeley, Illinois 60163 U.S.A.
Warm Air Hand Dryers
™
Possible Cause(s)
No power to unit
Defective motor
Defective heating element
or defective thermostat
Sensor is dirty, defective
or there is a reflection
™ WARM AIR HAND DRYERS, MODELS COVERED IN THIS MANUAL, ARE WARRANTED BY
Corrective Action
Check power to unit and connections
Replace motor brushes or motor if bad
Disconnect the unit from the electrical supply and remove
the cover. Check the heating element and thermostat with
a universal meter and replace if necessary
1. Check infra-red eye for dirt or damage. Use plastic lenses
cleaning solution and a soft cloth. Dry lens with a soft cloth
2. Make sure that sensor is not getting a reflection from
another object
3. Test relay/contactor for coil continuity using an ohm meter.
Coil resistance should not exceed 2000 ohms
4. After electricity has been applied to the dryer, it should
turn on within a few seconds. Test by placing hands
3 to 6 inches below the nozzle
(D)XA and (D)A
R