Inhaltsverzeichnis
Werbung
5-2 Adjusting the Level Adjusters
1.
When the monitor cabinet is in its final position, lower the four (4) level
adjusters with a spanner so that the machine is level and all castors are
raised from the floor by approx. 5mm. Tighten the lock nuts with a
spanner to ensure that the level adjusters do not move.
Note:
If the location site of this machine has a polished floor it is
recommended that rubber pads are fitted under the level adjusters to
prevent the machine sliding on the floor when in use.
5-3 Fitting the Coin Tower
1.
Remove 4off security screw (M5x12) and remove the joint box top cover.
2.
Place the coin tower up to the joint box taking care not to trap any wires.
Page 37
Werbung
Inhaltsverzeichnis
