Maintenance And Service - Compac FP16 Bedienungsanleitung

How to raise and lower the table:
1. Raise the table slightly above the required working height.
2. Insert the pins in the holes. Make sure that the table is level.
3. Place the straightening blocks and the press is ready for use.
Please note that the item must be supported by both straightening blocks when applying a pressure of
70% of the maximum capacity or more, to avoid damage to the straightening blocks.

Maintenance and service:

The press must be inspected visually by a skilled person for any leakages or damages. This
inspection is to be repeated at least every 12 month.
The hydraulic system is self lubricating. Change the oil every 1 to 2 years.
Oil specification: Hydraulic oil viscosity from 22° to 32° cSt/40°C.
Oil quantity: 1.4 L.
Avoid dirt, dust and other particles getting into the hydraulic system when changing the oil.
Lubricate moving part and pivot points regularly.
Trouble shooting:
If the press is very hard to pump and will not make high pressure:
1. See operating instruction "How to operate the pump", position 3.
If the piston does not approach or return smoothly or the piston will not reach maximum stroke:
1. Check that the correct oil plug with the small hole is mounted.
2. Check the oil level is correct and fill up to required level if necessary.
3. Pump the piston to maximum stroke and return. Repeat this 2 - 3 times.
Use only original spare parts.
Decommissioning:
If the press should ever be scraped, then please drain the oil into an approved container and dispose
of it to the appropriate authorities.
2/2 2004.04.22