Using The Device - INVENTOR EP-ST32 Bedienungsanleitung

Battery charging
Tip:
When operating the device for the first time the battery will not be fully charged. Please
remember to charge up before first usage.
Operation instruction
1.Put the body on horizontal surface. Connect the adaptor to the
charging port on the battery pack and plug in the adaptor to the
socket. When the battery is charging, the power indicator will
blink continuously. One minute after the battery is fully charged,
the indicator will switch off.
2. The approximate charging time of this appliance is 4 to 6 hours.
In Max mode the battery autonomy reaches the 15 minutes.
In Low mode the battery autonomy reaches the 40 minutes.

USING THE DEVICE

Operation instruction
1. Press down "Power button" to start
2. Press down "Power button" again to stop
3. The battery should be recharged only when there is one power light indicator on the led
screen and continuously blinks.
4.The tube can be bent when needed. Pull the black plastic cover of the tube upwards along
the arrow, then the tube will be bend.
6
ΕΝ
Charging
port