Clock Functions; Setting The Time; Displaying The Time - JGC -UR-210 Bedienungsanleitung

CLOCK FUNCTIONS

Setting the time

• The time can only be set when in standby mode (radio turned off but still connected to the power supply).
• Press the TIME SET/MEMORY button (8). The hour will blink in the display (11).
• Then press the DOWN (3) or UP (2) button to set the hour and confirm the selection with the TIME SET/
MEMORY button. Set the minutes using the same procedure.
• After the minutes have been set and saved, the time will automatically be displayed.
If you do not press any button for approx. 5 seconds, then the display changes back to whatever was
previously shown. You must then press the TIME SET/MEMORY button again.

Displaying the time

• After you have turned on the radio with the ON/OFF button (6), the time is no longer shown in the
display (11).
• To see the time, press the MODE button (10). The time will be shown in the display for approx. 4 seconds.
Then the display changes back to what was previously shown.
Waking up with the radio
• You can set the alarm so that when it is activated, the radio turns on.
• The wake up time can only be set in standby mode (radio turned off but still connected to the power supply).
• Press the SLEEP/WAKE button (5). The radio symbol
blinking in the display (11) and the hour will also blink on 0 (fig. 5).
• Press the DOWN (3) or UP (2) button to set the hour and confirm the
selection with the SLEEP/WAKE button. Set the minutes using the same
procedure.
• After the minutes have been set and saved, the time and the radio
symbol will be automatically displayed.
• To turn off the alarm, press the SLEEP/WAKE button. The symbol disappears from the display.
If you do not press any button for approx. 5 seconds, then the display changes back to whatever was
previously shown. You must then press the SLEEP/WAKE button again.
26
JGC-UR-210-IM-DE-EN-V3.indb 26
will be shown
Fig. 5
03/12/2009 10:41 AM