Cleaning And Care, Troubleshooting; Cleaning The Housing - JGC -UR-210 Bedienungsanleitung

CLEANING AND CARE, TROUBLESHOOTING

Cleaning the housing

• Pull the plug out of the wall outlet before every cleaning.
• Remove dust with a soft dusting cloth.
• Do not use a wet sponge, wax, spray polishes, or abrasives.
• Caution: No water must reach the housing. If so, unplug the power cord and let the device dry thoroughly
before operating it again. Please do not dry the device in an oven or microwave oven.
Troubleshooting
• If an error occurs, check the table below first, before you contact your dealer or send in the device. The
address and hotline number can be found on the warranty card.
• Do not open the device and do not try to repair it yourself. You will lose the warranty claim and it is
dangerous!
• Refer to the warranty conditions on the following pages.
Problem
No sound.
The display is blank;
no reaction to
pressing buttons.
Disturbances when
playing radio.
28
JGC-UR-210-IM-DE-EN-V3.indb 28
Possible cause
The volume is set too low.
The plug (21) is not plugged in
correctly.
Electrostatic discharge.
The buttons are locked.
The station is not properly tuned.
Telecopic antenna is not pulled
out.
The device is positioned in a
location with poor reception.
Solution
Set the volume higher.
Plug in.
Switch off device and pull the plug. Wait briefly and
plug in again.
Unlock the buttons with the switch LOCK (13).
Tune the station again.
Pull the antenna fully out.
Find the optimum position for the device.
03/12/2009 10:41 AM