Clock Functions; Operating The Radio; Setting The Time; Setting The Alarm - JGC -URCD-20 Bedienungsanleitung

CLOCK FUNCTIONS

Operating the radio

• Slide the FUNCTION switch (22) on the device to AM or FM. If the function switch is in the AM position, the
device is operating in the AM radio range. If the function switch is in the FM position, the device is operating
in the FM radio range.
• Select the desired radio station by means of the TUNING control (27).
• The LED indicator FMST. (C) will come on, if you are receiving a FM stereo station. Only FM stations are
broadcast in stereo.

Setting the time

• After you have connected the power plug (25) to a power outlet, the time 12:00 will blink in the display (7).
• Hold the CLOCK/ADJ. button (18) down for 2 seconds. Either 24 H or 12 H will be shown in the display. To
change the time configuration, hold the CLOCK/ADJ. button (18) down again for 2 seconds. If you choose
the 24-hour time format, the time of 0.00 will blink in the display panel. For the 12-hour time format, the
time 12:00 will blink in the display.
• Press the
Confirm by pressing the CLOCK/ADJ. button.
• If you select the 12-hour display, the LED indicator PM (D) will also be displayed for times after noon.
• If you would like to reset the time again later, press briefly on the CLOCK/ADJ. button. The time will blink in
the display. Set the time by means of the
CLOCK/ADJ. button.

Setting the alarm

• You can set a time to wake up at which the device will come on either in the radio or CD mode. Or you can
be awakened by an alarm signal. You can save two wake-up times in total.
• Press the ALARM1 (15) or the ALARM2 (14) button. The time digits will blink in the display.
• Set the wake up time with the
either the ALARM1 or ALARM2 button.
• The LED indicator AL.1 (J) or AL.2 (I) will light up. If you have saved 2 wake up times, both LED indicators
will come on.
• Set the desired volume by turning the volume control (23) on the device.
• Set the FUNCTION switch (22) to CD, if you would like to be awakened by music from a CD. Make sure that
there is a CD in the CD compartment (1).
• Set the FUNCTION switch to AM or FM, if you would like to be awakened by the radio. Select the desired
radio station by means of the TUNING control (27).
• Set the FUNCTION switch to BUZZER/AUX IN in order to be awakened by an alarm signal.
30
JGC-URCD-20-IM-DE-EN-V1.indb 30
Downloaded from www.Manualslib.com
/MINUTE button (12) to set the minutes and the
The time will not be saved, if you pull the plug (25) and if there are no batteries in the battery
compartment (24) on the back of the device. In that event, set the new time again.
/MINUTE (12) and
manuals search engine
/HOUR button (11) to set the hours.
/MINUTE and /HOUR buttons and confirm by pressing the
/HOUR (11) buttons and confirm it by pressing
29/01/2010 5:26 PM