Grouping In Parallel Linking Configuration - Glamox MPP-SEN Bedienungsanleitung

Grouping in Parallel linking configuration

In parallel linking configuration you need to group the ballast if you need more then one group.
There are 4 groups to choose from.
To start the process press the "DALI address" button. All lights will then go to maximum and then start to search
for connected devices (this might take some time). Each time a device is found it will be set to minimum level.
When all devices are found one of them will start flashing. You then press 1, 2, 3 or 4 according to which
group you want that device to belong to. After pressing the correct number the next, randomly chosen, will start
to flash and then you assign that device to a group. This sequence will continue until all luminaires are assigned
to a specific group. When the last device is assigned the full system will flash two times and all luminaires will
return to their default settings.
Celebrating Daylight Regulation (DLR)
1. Place the lux-meter at the desk underneath
the sensor
2. Dim the light up/down, using the remote,
until the correct light level is reached
3. Press the save button on the remote
4. Light will blink twice to indicate that the
set point is stored
Change background level
Background level is a light level you set when you need to remain a certain level even when no one is present
(see also mode setting on page 8). When entering a large room using "occupancy sharing" the zone(s) that
have no occupancy will go to background level (see more on page 12).
1. Press " % "
2. Select your background level by pressing
1=10%, 2=20%, 3=30%, 4=40%, 5=50%,
6=60%, 7=70%
3. Wait until the red LED stops blinking.
4. Point the front of the remote to the multi sensor
LRI1663 and press the green send button.
Group 1 = Window area
Group 2 = Corridor area
Group 3 = Middle row area, decorativ lighting
Group 4 = Blackboard lighting
9