Glamox MPP-SEN Bedienungsanleitung Seite 10

Other important settings done by the remote control
Walk test mode
In order to test the coverage of the PIR you set the system in walk test mode by pressing the "Test"
button. All lights will flash once and go to minimum level. In walk test mode the luminaires go to 100%
for 1 second when presence is detected. For extension sensor it goes to 100% for 60 second. It will
exit from walk test mode after 60 second with no detection of movement.
Auto 100h burn in
Resetting the Glamox MPP-SEN
If needed the Glamox MPP-SEN can be reset to default setting by using the remote in the following
way.
Sensitivity PIR
2. 3.
10
Press "Test" button and the lamps will flash once.
Press "100 h" and the lamps will flash twice.
Press ">0<" button .Then press the green send button.
1. Press >PIR< button. Red LED will flash.
2. Then press 1 for high sensitivity or 3 for low sensitivity.
3. Finally press the green "SEND" button.
1.