Glamox MPP-SEN Bedienungsanleitung Seite 6

General sensor parameters
Light sensor
PIR
Factory setting: 15min delay time
Service button
Switching between mode 1 and 2
See page 8 for more information.
Push button, 1 flash = Mode 1, 2 flash = Mode 2
6
Factory setting: 600lux with average reflection value 0,6
Y≥0.6 x H
H
0.7 x H
8m
H=2.7m
Recommended placement
Area coverage at 3m height.
NOTE: Do not place the sensor directly under the
air outlet in the HVAC since the temperature different
between the incoming air and the ambient temperature
might trigger the PIR sensor.