Pioneer DR-R102 Bedienungsanleitung Seite 9

5. Attach the rear panel of the Changer.
6. Affix CD-R drive function switch
label
As the printed instruction on the rear
panel is for a ROM drive, affix the label
to indicate the correct CD-R drive
functions. (Affix the label so that it covers
the original lettering.)
7. Set the SCSI ID.
For futher details, see A Hardware Tour
(p. 6) and the changer operating manual.
Note:
When setting the SCSI IDs, be careful not
to leave the pointer arrow of the SCSI ID
switch between two figures; be sure to set
the switch so that the arrow points a single
figure.
8. Set the function switches (SCSI
terminator & parity switches)
Set the terminator switch of the last drive
in the daisy-chain connection to ON.
For futher details, see A Hardware Tour
(p. 6) and the changer operating manual.
INSTALLING THE CD-R DRIVE
O
N
1 2
CD–R DRIVE
CD–R DRIVE
OFF
ON
SCSI Terminator
CD–R DRIVE
Function switch
label
1 2
Parity
9
<DRC1128>
En