Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. DEMOUNTING THE LOAD CARRIER :
- To demount the Van 'n Bike load carrier, you need to be with 2 people.
Open the Van 'n Bike load carrier. The first person supports the frame of the carrying system, while
the second person disconnects the DIN connector. Disconnect the locking mechanism of the
telescopic arm on the side of the hinge. Then the second person takes the split pins away from the
hinge axes and removes these axes. The carrying system is now completely loose and can be
removed.
5. MOUNTING THE LOAD CARRIER :
- To install the Van 'n Bike load carrier, you need 2 people.
The first person supports the frame of the carrying system with the hinge points against the hinge
points on the vehicle , in such a way that the second person can slide the hinge axes of the system,
onto those of the vehicle.
- Then insert the split pins at the bottom of the hinge axels
- Fix the telescopic arm on the hinge attachment with the provided locking mechanism.
- Attach the DIN connector in the provided clamp which can be found at the rear of the carrying
system.
6. INSTALLING AND REMOVING THE BICYCLE CARRIER ON THE Van 'n Bike LOAD CARRIER :
- Take your bicycle carrier and place it over the ball mount.
Place the bicycle carrier as provided for in the instructions for use of the bike carrier.
- Insert the plug of the bicycle carrier in the female plug of the Van 'n Bike load carrier and attach
both plugs in the provided clamp at the bottom of the back of the carrying system.
After mounting the bike carrier onto the Van 'n Bike carrying system, place the enclosed Van 'n Bike
strap between the toggle of the bicycle carrier and the notch in the centre of the carrying system.
The strap does not need to be tightened too much because enough tension will be put on the strap
when loading.
Placing this strap is important to distribute the weight that rests on the ball mount over the entire
carrying system.
- To demount the bike carrier you go to work in reverse order.
- Optionally, an adjustable bike arm can be placed between the first bike and the Van 'n Bike carrying
system. This ensures that the bicycle handlebar can remain in its normal position during transport.
Moreover, it ensures that the bicycle handlebar, during a sudden braking movement of the vehicle,
does not collide with the rear doors of your camper.
- When using a bike carrier with 3 or 4 bicycle gutters, with transport of 3 to 4 bikes, it is advisable to
apply the heavy-duty system to the Van 'n Bike carrier system, to distribute the total weight over the
entire carrying system.
7. WARNINGS:
14
Werbung
