Noise And Vibration; Description Of Functions And Applications; Operating Instructions - Felisatti DC10/14,4L2 Original Bedienungsanleitung

Noise and vibration

1) Noise emission Measured values are according
to EN 60745-2. The operator should wear hearing
protection.
A weighted sound power leval
[LWA] [dBA]
A weighted admision leval [dBA]
Uncertainty [K] [dBA]
3) Vibration emission
Vibration total values(triaxial vector sum)
Vibration total values(triaxial vector sum)
Vibration value (ah) [m/s2]
Drilling
Mode
Uncertatey (k) [m/s2]
4) The following information
• The declared vibration total value has been
measured in accordance with a standard test
Method given in EN60745 and may be used for
comparing one tool with another.
The declared vibration total value may also be
used in a preliminary assessment of exposure.
5) A warning
• The vibration emission during actual use of the
power tool can differ from the declared total value
depending on the ways in which the tool is used.
• Identify additional safety measures to protect
the operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when
it is running idle in addition to the trigger time).
8
5
88
77
3
2.5
1.5
Description of Functions
and Applications
1. Description of Functions
• DC10/14,L2 •
• Battery • FL14415 •
• Charger • F144 •
2. Applications
For drilling in woods and screwing, metals,
plastics or other non concrete materials.

Operating Instructions

1. How to charge the battery
1) Insert the plug of the charger in the socket, and
the charging indicating lamp will be flickered in
green, red and yellow in turn within one second.
And then, the battery charger will be in the stand
by position.
2) Insert the battery in the battery charger
considering the polarity, and the charging will be
started immediately.
A new battery will work properly after five times
of charging and discharging. Charge and
discharge the battery, which is not used for
a long time, for two to three times to function
well.
3) When the battery working time is remarkably
short despite full charging, the life of the battery
may be over. Replace the battery immediately.
Take care not to short-circuit the terminal of
the battery. The short-circuit of the terminal
may cause a fire or explosion doing a serious
personal injury.
2. Charging process (Fig.4)
Use only the specified battery and battery charger.
Otherwise battery and charger can be damaged
by fire, explosion, charging error or overheat.
6
(Fig.1)
(Fig.2)
(Fig.3)
7