SUHNER ABRASIVE LTB 6-1030 Flat Originalbetriebsanleitung Seite 24

4.1.1 d /
etAching connecting the suPPly hose
Unscrew the coupling with the exhaust air hose so that it
can be pulled back and off.
Press the hose coupling to disengage it. You can now pull
out the air supply hose.
V
ery shArP BlAde
4.1.2 r
egrinding the BlAde
The blade can be reground with a commercially available
grinding machine. There are special adapter plates avail-
able for SUHNER blades.
V
ery shArP BlAde
4.1.3 h
Ardening the BlAde
Exclusively SUHNER steel must be used. This can be pur-
chased from the area representative or directly from the
manufacturer. Apply the steel under a light pressure. The
last pass should be along the inside of the blade. When
cutting does not improve, the blade must be replaced.
Contact the area representative or the manufacturer for
further information.
24
Make sure that the steel is held flat and over the blade's
centre line.
4.1.4 h
Before honing, clean the nose of all fat and meat residue.
!
The blade must be honed every day with a knife sharp-
ener or a stone.
!
With the motor running, hold the flat side of the whetstone
against the flat side of the blade. Move the whetstone
back and forth.
4.1.5 g
Use only food grade (FDA approved) lubricants, e.g.
TURBO LUBE GREASE (art. no. 60000078), TURBO
LUBE SPRAY (art. no. 60000077).
V
ery shArP BlAde
oning the BlAde
V
ery shArP BlAde
reAsing the BlAde
!
!