SANUS VuePoint F180 Bedienungsanleitung Seite 7

2 Mount the Wall Plate
Wood stud
2-1 Locate studs
40.6 cm
(16 in.)
2-2 Mark the wall
[01]
2-3 Drill pilot holes
2-4 Tighten lag bolts
[07]
[08]
6902-002024 <02>
< 16 mm
(5/8 in.)
[##]
Improper use could reduce the holding power of the lag bolt. To avoid
potential injuries or property damage
Verify the center of the stud(s) using an awl, a thin nail, or an edge to
edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (1.5 x 3.5 in.).
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage! Pilot
holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5 mm
(7/32 in.) diameter drill bit.
CAUTION:
Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts [08].
Tighten the lag bolts [08] only until the washers [07] are pulled
fi rmly against the wall plate [01].
13 mm 5.5 mm
(1/2 in.) (7/32 in.)
75mm
3 in.
7