Maestro MR037 Bedienungsanleitung Seite 8

- Connect the plug to the mains.
- Remove the kettle from the support.
- Press the button to open the cover, the cover will open.
- Fill the kettle with cold water up to the mark «MAX». Close the
cover (until it clicks).
- Place the kettle on the support.
- Turn the switch (C/ Fig.1) to the position «I». The indicator will
light signaling that the device has turned on, and the kettle shall
begin warming the water.
- When the water begins to boil, the switch will be turned to
the position «О» (off), the light will fade and the kettle will be
automatically turned off.
- You must pour out the first portion of water and repeat the boiling
procedure again.
- Now the kettle is ready for use.
ATTENTION! Do not fill the kettle with cold water until cools down;
let it get cool before filling with cold water.
The taste of plastic
- Usually the taste of plastic appears during the first boiling.
- Pour out the water boiled for the first time and repeat the
procedure several times.
- If the taste of plastic persists, fill the kettle with water till the mark
«MAX» and add 2 tea-spoons of soda. Boil the water and pour it
out.
Further boil water as specified above.
The level of water in the kettle must be somewhere between the
marks «MIN» and «MAX».
The process of warming the water can be interrupted at any
moment by pressing on the switch.
ATTENTION! If your kettle switches off before the water begins
8