Velleman CAMSETW16 Bedienungsanleitung Seite 5

• In dark environmental conditions, the built-in Infra-Red lights (4) will automatically become active. In
this night vision mode, the image will become monochrome (black and white). The night vision range is
limited to 7m.
• Use of the remote control:
Keys Function
Select channel keys (19)
Press '+' to show next channel, '-' to show previous channel (21)
Initialize loop:
1. In normal mode, press and hold the loop key (20) for 3 seconds. '
2. Press the channel selectors to indicate which channels need to be looped
3. Press the loop key (20) again to save the set-up. Scanning begins
Press the loop key (20) to start scanning all channels
Lock/Unlock the remote control to avoid accidental touches or interference from other IR
controllers. To lock, press the lock key (18) once (' ' is displayed for ±1s), to unlock, press
the lock key again (' ' is displayed for ±1s).
When the remote control is locked, the cannel button (17) on the receiver still works.
Battery
10.
• The remote control is battery operated. Before first use, remove the battery protection tape.
• To replace the battery, face the back of the remote control, push the small tab (1) to the right and pull
down (2, see image on page 2). The battery cover slides out of the remote control.
• Replace the old battery with a new lithium battery type CR2025. Make sure to use the correct polarity.
• Removing the battery when the device is not in use will extend the lifetime.
• Do not attempt to recharge batteries and do not throw them in fire as they may explode.
WARNING: handle Lithium batteries with care, observe warnings on battery casing.
Dispose of batteries in accordance with local regulations.
Keep the battery away from children.
Troubleshooting
11.
Image Sound
No No
Snow Noisy
Ghost image Normal
No colour Normal
Normal Noisy
CAMSETW16
Check power supply on camera and receiver.
Check whether camera and receiver are on the same channel.
Check whether the distance between camera and receiver is within limits.
Possible interference with other devices.
Check whether the distance between camera and receiver is within limits.
TV system mismatch (PAL/NTSC), or night vision enabled
Possible interference with other devices.
Possible reason/solution
5
' flashes
©Velleman
®