Velleman CAMSETW16 Bedienungsanleitung Seite 4

• manual and automatic channel scan
• transmitting range (depending on the surroundings): ±100 m without obstacles
• content:
2x camera + mounting hardware
1x receiver + antenna
1x AV cable
3x voltage adapter
1x channel pick tool
1x user manual
Overview
7.
Refer to the illustrations on page Error! Bookmark not defined. of this manual.
Camera
1 Antenna
2 Hood
3 Lens
4 IR lights
5 Universal bracket
6 Channel switch
7 Microphone hole
8 DC power jack
Receiver
9 Audio output (L)
10 Audio output (R)
Mounting
8.
• The camera can be mounted against the wall or the ceiling or simply placed on a desktop using the
universal bracket (5).
Note: the hood (2) can be removed by sliding it forward. To remount, start at the rear end of the camera
and slide forward until the holes in the hood (2) and camera are in line.
• When mounted on the ceiling, the universal bracket must be place on the top of the camera (closest to
antenna (1)). To do this, unscrew the universal bracket (5) from the housing and screw it in the
opening on top of the camera.
• The receiver should be placed horizontally antenna pointing upwards. The antenna can be rotated to
improve signal reception.
Operation
9.
• Mount the camera in a location that needs to be monitored.
• Apply power to the camera. Insert the jack from the adapter into the DC power jack (8) of the camera.
• When necessary (interference with other devices occurs or multiple cameras are used), set the channel
by opening the channel switch cover (6). There are 4 channels possible, default channel is 1. Close the
switch cover (6) after setting the switches.
• Point the antenna (16) of the receiver upwards. The antenna can be rotated in either direction. Do not
force the antenna.
• Connect the receiver to a monitor or TV via the video and audio output jacks (9, 10 & 11).
Note: YELLOW plug = video, RED plug = audio (R), WHITE plug = audio (L)
• Connect the DC power adapter to the DC power jack (12).
• Switch the power ON/OFF switch (15) to the ON-position.
• Power on the monitor or TV and select AV mode.
• The system is capable to support 4 cameras at the same time. Select the channel via the channel
select button (17). The current channel is indicated in the channel display (14).
• Press and hold the channel select button (17) for 3 seconds to go in loop mode; every channel will be
shown for 5 seconds.
• Adjust the brightness, contrast and colour settings of the monitor or TV to get the best display result.
Changing receiver and/or antenna location might improve the image.
CAMSETW16
11 Video output
12 DC power jack
13 IR receiver
14 Channel display (LED)
15 Power switch
16 Antenna
17 Channel button
Remote
18 Lock/unlock key
19 Channel selectors
20 Loop key
21 Channel up/down key
4
®
©Velleman