Android Smartphone - ELRO ROYALE BC3000 Anleitungshandbuch

app. To connect the camera to the ELRO Babycam app, you need to connect the adapter and set
the switch to the ON position first. You should then connect your phone to the Wi-Fi signal that is
transmitted by the camera. You can only connect the camera with a 2,4 GHz Wi-Fi signal (5GHz Wi-
Fi is not possible). If you have an Android smartphone, follow the steps under "Android
smartphone. If you have an iOS smartphone, follow the steps under "iOS smartphone".

Android smartphone

1 Press the reset button until the night light underneath the camera flashes 3 times.
2 Then, briefly press the reset button 1 time, the night light will quickly flash.
3 After 10 seconds, briefly press on the reset button 1 time, the night light will start to flash
slowly.
4 Now go to the Wi-Fi settings of your smartphone and connect to the Wi-Fi signal of the
camera ending on - - - - - 111A with your smartphone (Comment: This network does not have
access to the internet). If you are asked to switch to a different network, choose to cancel.
5 Open the ELRO Babycam app and add the camera by selecting "Add Device".
6 Then scan the QR code, which you will find on the bottom of the camera.
7 Fill in a name for the camera and 000000 at "Password", then press "OK".
8 The camera will now be online and the live view can be watched.
9 You will be asked to change the unsafe password '000000', select "OK". Fill the old and new
password and select "OK". The new password should contain at least 6 characters, one
uppercase letter, one lowercase letter, one digit and one special character (choose from:
~`@#$%^*()_-+=|{}[].?/).
10 Go to camera settings.
11 Select "Wi-Fi setting" to change the Wi-Fi Setting of the camera to your own network.
12 At SSID, select your own network (Home network).
13 Enter the password of your own network here and select "SEND". By selecting the eye symbol
on the right side, you can see what you are typing. After selecting "SEND", the camera stops
transmitting its Wi-Fi signal. The night light at the bottom of the camera stops flashing slowly,
then lights continuously.
14 You will then be asked to close the app. Open the app again after the light has turned off and
you have seen 3 short light flashes.
15 Swiping from left to right or from top to bottom allows you to point the camera in the desired
position (Pan/Tilt adjustment).
Comment
If the installation has failed for some reason, start over at the beginning of this chapter. Disconnect
the camera from the power by turning the camera off and then removing the adapter from the
power outlet. You could also try the alternative connection method explained below.
- 9 -