Replacing The Lamp - AEG SDS51400S0 Benutzerinformation

32 What to do if...
Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on the
ground.
The temperature in the ap-
pliance is too low.
The temperature in the ap-
pliance is too high.

Replacing the lamp

1. Disconnect the mains plug from the mains socket.
2. Remove the screw from the lamp cover.
All manuals and user guides at all-guides.com
Possible cause
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
The melting water outlet does
not flow in the evaporative tray
above the compressor.
The temperature regulator is
not set correctly.
The temperature regulator is
not set correctly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at
the same time.
There is no cold air circulation
in the appliance.
Solution
Do not keep the door open lon-
ger than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.