Bosch ALM 34 Bedienungsanleitung Seite 12

EURO • Printed in England • BA F016 L69 850 • ALM 34 • OSW
F016 L69 850.book Seite 2 Donnerstag, 17. Januar 2002 1:58 13
Product Specification
Quiet Lawn Mower
Part number
Rated power [W]
Blade width [cm]
Height of cut [mm]
Positions
Weight [kg]
Protection class
Serial Number See rating details on
machine
Intended Use
This product is intended for domestic lawn mowing.
Introduction
This manual gives instructions on the correct as-
sembly and safe use of your machine. It is important
that you read these instructions carefully.
When fully assembled the machine weighs approxi-
mately 6.5 kg. If necessary, obtain assistance to re-
move from packaging.
Take care when carrying the mower to the lawn, as
the blades are sharp.
Delivered Items
Carefully remove the machine from its packaging
and check that you have all the following items:
– Lawnmower with handle assembly
– 1 Handle bottom
– 2 Bolts
– 2 Wing nuts
– 2 Pivot pins
– 2 Cable clips
– Spanner/scraper
– Operating instructions
– Spare parts list
When parts are missing or damaged, please contact your
dealer.
12 • F 016 L69 850 • TMS • 15.01.02
Operating Controls
1 Switch lever
ALM 34
2 Safety button
0 600 887 1..
1 150
3 Handle top
34
4 Mains plug**
10/32
5 Cable restraint**
4
6 Handle bottom
6.5
**Country specific
/ II
Not all of the accessories illustrated or described are
included as standard delivery.
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
The blades continue to rotate for a few sec-
onds after the machine is switched off.
Caution - do not touch rotating blades.
Electrical Safety
Your machine is double insulated for safety and re-
quires no earth connection. The operating voltage is
230 V AC, 50 Hz. Only use approved extension ca-
bles. Contact your service agent for details.
Extension cords/leads should only be used if they
comply with H05VV-F or H05RN-F types.
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
For products not sold in GB: WARNING: For
safety, it is essential that the mains plug 4 attached
to the machine is fitted to the power supply cable 11.
(see figure
The couplings of connection leads must be pro-
tected against splashes and the coupling sockets on
the leads must be made of rubber or coated with
rubber.
Fixing means for the connection leads must be
used.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used if
in perfect condition.
If the supply cord is damaged, it must be replaced by
a Bosch Service Center.
Products sold in GB only: Your mower is fitted with
an approved 13 A (BS 1363/A) electric plug and is
protected by a 13 A fuse (ASTA Approved to
BS 1362).
English - 2
For Your Safety
)
B