Kong Cam Clean Bedienungsanleitung Seite 21

(C) Safety device for the toothed cam in aluminum alloy,
All manuals and user guides at all-guides.com
(D) opening for the connection to the bottom harness, (E)
opening for the connection to the chest piece.
8.1 – CONNECTION TO THE HARNESS
Fig. 2 – Connect the device:
- to the bottom harness with a quick link, inserted between
the opening (D) and the ventral attachment point of the
harness,
- to the upper part/chest part of harness through an
accessory cord or a connector, inserted between the
opening (E) and the attachment point of the upper part/
chest part of harness, keeping the clamp in vertical
position and close to the body in order to allow the slide on
the rope.
Warning: never use the rope clamp without connecting it to
the upper part/chest part of harness (fig. 3).
8.2 – POSITIONING ONTO THE ROPE
Fig. 4 – How to fit the device onto the:
- turn and lock the tooth (B) into the open position taking the
safety device to the outside of the body (A),
- insert the device onto the rope checking that it lies in the
direction marked on the body (A),
- release the tooth (B), pressing it towards the rope,
- make sure that safety device (C) is positioned on the
inside of the body (A) and prevents the tooth (B) from fully
opening.
In conditions of absolutely safety, before using the device,
verify that:
- it is positioned in parallel with the rope,
- it slides in the right direction (upwards),
- It locks in the other direction (downwards) - Fig. 5.
8.3 – PROCEDURE FOR USING THE VENTRAL ROPE
CLAMP (EN 567)
Fig. 6 – The foot rope clamp "FOOT FUTURA", used together
with the ventral rope clamp and a handle and/or BODY
FUTURA, helps to keep the user's body upright facilitating
ascent. Warning: "FOOT FUTURA" is not a personal
protective equipment (PPE) and must therefore never be
used on its own!
Warning, rope clamps are not fall-arrester devices: make
sure that there are no slacks on the rope (fig. 7).
Warning:
- never push the device up against the knot: it could be very
difficult to release it, if not possible (fig. 8),
- use your thumb to work the toothed cam (B) to make the
device slide downwards (fig. 9), do not touch the tooth's
safety device (fig. 10): risk of accidental opening!
8.4 – PROCEDURE FOR USING THE ASCENDER ON THE
WORKING ROPE (EN 12841)
Warning: before positioning the device onto the working rope
verify that:
- the anchoring points, both of the working rope and the
safety rope, are above the user and conform to standard
EN 795,
- the connector are fitted with a gate locking device and
conform to standard EN 362, the system used to connect
the handle to the harness is no more than 1 meter long.
Fig. 4 – Correctly positioned on working line (read p.to 8.2).