Initial Steps - LA VAGUE LV-HD320 Benutzerhandbuch

INITIAL STEPS

Connecting the power cable
Connect the power cable to the side of the projector and to a power outlet. If the
indicator light at the top of the projector turns red, the projector is in standby mode
Power up
Remove the lens cap from the lens.
Press the „Power" button on the top of the projector or the „Power" button on the
remote control. If the indicator light on the top of the projector is steady green, the
projector is turned on.
Press the „Power" button again either on the projector or on the remote control to
turn off the projector.
Keystone correction/
image focusing
Use the rear keystone adjustment dial
located at the top of the projector to
adjust the angle of the projector. Use
the front keystone adjustment dial, also
located on the top of the projector, to
adjust the image focus.
Selecting the signal source
Press the „S" button on the projector
or the „Source" button on the remote
control to open the menu for selecting
the input signal.
Use the arrow buttons on the remote
control or on the projector to select the
appropriate signal source and confirm
with „OK".
12