Initial Steps - LA VAGUE LV-HD200 Benutzerhandbuch

INITIAL STEPS

1. Connecting the power cable
Connect the power cable to the side of the projector and to a power
outlet. If the indicator light at the top of the projector turns red, the
projector is in standby mode
2. Power up
Press the „Power" button on the top of the projector or the „Power"
button on the remote control. If the indicator light on the top of the
projector is steady green, the projector is turned on.
Press the „Power" button again either on the projector or on the remote
control to turn off the projector.
Remove the lens cap from the lens.
To raise or lower the front of the projector, turn the adjustable foot
located on the bottom of the projector.
19