Behringer KM1700 Schnellstartanleitung Seite 16

16
KM1700/KM750
KM1700/KM750 Controls
Step 2: Controls
(EN)
(1) PROTECTION LED lights when the amplifier
goes into thermal protection mode to
cope with temperatures over 90°, or if the
amplifier's functioning has become unstable.
(2) SIG LED lights to indicate that a signal is
present at the LED's respective channel input.
(3) CLIP LED lights when the output
signal exceeds the amplifier's clean
headroom capacity. In normal operation,
the CLIP LED may light from time to time,
but should never light continuously. If the
CLIP LED lights continuously, turn down the
output level.
(4) BRID LED lights to indicate that the
amplifier's rear MODE switch has been set to
BRIDGE mode.
(5) POWER LED lights to indicate that the
amplifier is powered on.
(6) MONO LED lights to indicate that the
amplifier's rear MODE switch has been set to
MONO mode.
(7) CH A/CH B CONTROLS adjust the
input level. To increase signal gain, rotate the
knobs clockwise; to reduce the gain, rotate the
knobs counter-clockwise.
(8) POWER switch turns the unit off and on.
(9) RACK EARS secure the unit into a rack using
four attaching screws and washers (fasteners
not included). Requires two rack units.
VOLTAGE SELECTOR lets you match
(10)
the amplifier to the local power system.
Please ensure this switch corresponds to the
actual power voltage available in your area.
If in doubt, consult an electrician.
POWER SOURCE jack accepts the included IEC
(11)
power cable.
TWIST- LOCKING SPEAKER OUTPUTS
(12)
connect the amplifier to the speakers using
professional speaker cables with
twist-locking plugs.
BINDING POST outputs accept bare wire
(13)
connections from speaker cables.
GROUND LIFT switch can be used to
(14)
eliminate humming caused by ground loops.
When placed in the LIFT setting, the switch
breaks the electrical connection between
the shield/ground of the input signal
and the power amp housing to eliminate
ground loops. In normal operation, set the
switch to the GND position.
LIMITER switch activates the internal limiter.
(15)
MODE switch selects between MONO, STEREO,
(16)
and BRIDGE operation modes.
2 2 2