Bluetooth ® Pairing - Hama BTH Run Bedienungsanleitung

• The display lights up constantly in red during the
charging process.
• It takes around 2-3 hours until the battery is
completely charged.
• Once the charging process is complete, the red
light of the LED (3) turns to blue light.
• Disconnect all cable and mains connections
after use.
5. Operation
Switching the headset off/on
• Press the MF button (5) until a voice says "Power
ON" and the blue LED flashes.
• To switch it off, press and hold the MF button
(5) until a voice says "Power OFF" and the red
LED flashes.
Note
The functions described in this section are only
available for Bluetooth
5.1. Bluetooth pairing
®
Note – Pairing
• Make sure that your Bluetooth
terminal device is on and Bluetooth
activated.
• Make sure that your Bluetooth
terminal device is visible for other Bluetooth
devices.
• For more information, please refer to the
operating instructions of your terminal device.
• The headset and the terminal device should not
be any further than 1 metre away from each
other. The smaller the distance, the better.
• Switch the headset on using the MF button (5).
• Press and hold the MF button (5) until the red
and blue LEDs flash alternatingly. The headset is
searching for a Bluetooth
• Open the Bluetooth
device and wait until Hama BTH RUN or Hama
BTH ACTIVE appears in the list of Bluetooth
devices found.
• Select Hama BTH RUN or Hama BTH ACTIVE and
wait until the headset is listed as connected in the
Bluetooth settings on your terminal device.
®
Note – Bluetooth
®
Some terminal devices require a password in order
to connect to another Bluetooth
-capable terminal devices.
®
-capable
®
is
®
-capable
®
connection.
®
settings on your terminal
®
password
device.
®
Note – Bluetooth
• If your terminal device requests a password for
connection with the headset, enter 0000.
Note
• Once the connection has been established, a
voice says, "Connected".
• If the connection attempt takes longer than
300 seconds to complete, it is cancelled and
the LEDs go out. In this case, repeat the steps
listed previously under 5.1 Bluetooth
5.2. Automatic Bluetooth
successful pairing)
Note
• Make sure that your Bluetooth
terminal device is on and Bluetooth
activated.
• Make sure that your Bluetooth
terminal device is visible for other Bluetooth
devices.
• For more information, please refer to the
operating instructions of your terminal device.
• Switch the headset on using the MF button (5).
The blue LED begins to flash and the headset
automatically connects with the last terminal
device used.
®
Note
• Once the connection has been established, a
voice says, "Connected".
• If the connection attempt takes longer than
300 seconds to complete, it is cancelled and
the LEDs go out. In this case, repeat the steps
listed previously under 5.2.
• It may be necessary to make settings on
your terminal device to enable automatic
connection with the paired headset.
Note – Connection impaired
®
After the headset and terminal device have been
paired, a connection is established automatically.
If the Bluetooth
automatically, check the following:
• Check the Bluetooth
device to see whether Hama BTH RUN or Hama
BTH ACTIVE is connected. If not, repeat the
steps listed under 5.1. Bluetooth
• Check whether obstacles are impairing the
range. If so, move the devices closer together.
password
®
connection (after
®
-capable
®
-capable
®
connection is not established
®
settings of your terminal
®
®
pairing.
®
is
®
®
pairing.
3