Electrical Safety - Black & Decker KG68 Handbuch

E N G L I S H
Follow the instructions for maintenance and
changing accessories. Keep handles and
switches dry, clean and free from oil and grease.
20. Repairs
This tool complies with relevant safety
requirements. Repairs should only be carried
out by qualified persons using original spare
parts; otherwise this may result in considerable
danger to the user.
Additional safety instructions for angle grinders
Wear safety glasses or goggles when
operating this tool.
Wear ear protection when operating this
tool.
Wear gloves when operating this tool.
Do not cut or grind light metal with a
magnesium content exceeding 80%, since
this type of metal is flammable.
Only use grinding and cutting discs and other
accessories recommended in this manual.
Make sure that the maximum speed of the
grinding or cutting disc exceeds the no-load
speed of the tool.
Do not cut workpieces requiring a maximum
depth of cut exceeding that of the cutting disc.
Never use the tool without the guard, except
for sanding.
Do not exert side pressure on the grinding or
cutting disc.
Sanding
Preferably wear a dust mask whenever sanding.
Thoroughly remove all dust after sanding.
Take special care when sanding paint which is
possibly lead based or when sanding some
woods and metal which may produce toxic
dust:
- Wear a dust mask specifically designed for
protection against lead paint dust and fumes
and ensure that persons within or entering
the work area are also protected.
8
SAG.P65
- Do not let children or pregnant women enter
- Do not eat, drink or smoke in the work area.
- Dispose of dust particles and any other
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Mains plug replacement (U.K. & Ireland only)
Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorised
repair agent or a qualified electrician.
Disconnect the plug from the supply and
remove the fuse from the plug.
Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
The cable wire colours, or a letter, will be
marked at the connection points of most good
quality plugs. Attach the wires to their
respective points in the plug (see above).
Brown is for Live (L) (2), blue is for Neutral (N) (4).
Before replacing the top cover of the mains
plug ensure that the cable restraint (3) is
holding the outer sheath of the cable firmly
and that the leads are correctly fixed at the
terminal screws.
If the plug has a fuse cover, make sure that the
fuse cover is fitted.
8
the work area.
debris safely.

ELECTRICAL SAFETY

This tool is double insulated in accordance
with EN 50144; therefore no earth wire is
required.
17-07-2001, 14:51