B) Charger, Charging; C) Operation - VOLTCRAFT VC 900 A Bedienungsanleitung

b) Charger, Charging

- The included plug-in charger must only be operated at a mains voltage of 230V~/50Hz.
- Set-up of the mains adapter is constructed pursuant to protection category II.
- Never use any other charger than the included one to charge the quick-start system.
- The corresponding cable with cigarette lighter plug is included for charging at a cigarette lighter socket.
- Charging lead batteries can lead to the formation of explosive gases. Therefore, always perform charging
only in well-ventilated rooms. Never charge lead batteries in containers or in badly ventilated rooms.

c) Operation

- The starting aid is only permissible for vehicles with 12V-board grid. For a board grid with a different
voltage (e.g. 6V or 24V), there not only is a danger of explosion by the rechargeable battery in the
quick-start system or vehicle; all the electronics components in the board grid may also be damaged!
- Before providing starting aid, always observe the operating instructions of the vehicle regarding how
starting aid can be provided. Improper starting aid may pose a danger of damage to the electronics
components in the board grid!
- The product is intended only as starting aid for vehicles with own rechargeable batteries. The quick-
start system is not suitable to replace a drive battery.
- Never try to perform starting aid for a frozen battery; danger of explosion!
- Select a stable, level, sufficiently large site for operating the product so that it cannot tilt or fall off. Oper-
ate and store the product only standing up.
- Never operate the product in closed insides of vehicles; observe sufficient ventilation!
- The product must not be operated close to flammable materials or gases. There is a danger of explosion!
- Never leave the product unattended while operating. Despite a considerable number of protective cir-
cuits, it is impossible to exclude the possibility of malfunctions during operation.
- Only operate the product in moderate climate, never in tropical climate.
- Ensure that there is sufficient ventilation during and after operation. Never cover up the product.
- Never operate the device immediately after it was taken from a cold room to a warm room. This caus-
es formation of condensation, which may not only lead to functional impairment, but also poses the
danger of potentially fatal electric shock!
- Therefore, first let the product reach room temperature before using it. This may take several hours!-
The compressor integrated in the quick-start system is not suitable for continuous operation, but only
for short-term operation. Let the compressor cool off for at least 10 minutes after operation before using
it again.
- When using the compressor, observe correct filling pressure (e.g. of a tyre). Overpressure causes a
danger of explosion!
- If the installed voltage converter is directly connected to the vehicle battery via the connection cables,
the vehicle must not be moved. Disconnect this connection before driving.
- The voltage converter can only supply 230V~-consumers with a maximum power intake of 200 W.
20