Possible Cause - Philips Lumea SC1997 Bedienungsanleitung

Rated frequency
Rated input
Protection against electric shock
Protections rating
Operating conditions
Spectrum of body attachment
Spectrum of precision attachment
Troubleshooting
Problem
The device/adapter
becomes warm during use
When I place the device on
the skin it does not release
a flash. The ' ready to flash
light blinks orange and
then lights up orange
continuously.
The 'ready to flash light'
doesn't light up when I
place the attachment on
my skin, but the cooling fan
works.
The 'ready to flash light'
lights up white but the
device does not produce a
flash when I press the flash
button.
I cannot increase or
decrease the light intensity
settings/All intensity lights
are blinking alternately
The device produces a
strange smell.
This chapter summarizes the most common problems you could encounter
with the device. If you are unable to solve the problem with the information
below, visit www.philips.com/support for a list of frequently asked questions
or contact the Consumer Care Center in your country.

Possible cause

This is normal.
You skin tone in the area to
be treated is too dark.
The overheat protection has
been activated.
The device needs to be reset. To reset the device, switch it off and
The device needs to be reset. To reset the device, switch it off and
The attachment or the filter
glass is dirty.
You have not removed the
hairs on the area to be
treated properly. These hairs
may get burned and can
cause the smell.
50Hz-60Hz
36W
Class II
IP 30 (EN 60529)
Temperature:+15 ºC to 35 °C
Relative humidity: 30% to 95%
>530nm
>600nm
Solution
No action required.
Treat other body areas with lighter skin
tones with Lumea.
When the overheat protection has been
activated, the fan still works. Do not
switch off the device, but let it cool down
for approx. 15 minutes before you
continue to use it.
switch it on again.
switch it on again.
Clean the attachment carefully.
Pretreat your skin before you use Lumea.
English
17