Operating Instructions; Switching On The Appliance; Setting Temperature - OK. OFZ10011A1 Bedienungsanleitung

6

Operating instructions

Clean appliance prior to initial operation
The appliance and the parts of the interior have to be cleaned thouroughly before first
use. See also chapter ‚Cleaning and care'.

6.1 Switching on the appliance

DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FRIDGE.
Operating tips
■ After the appliance has been switched on, it may take several hours until
the set temperature has been reached. Do not put any food in the appliance
beforehand.
■ The sides of the housing are sometimes heated slightly. This prevents
condensation in the area of the door seal.
■ If the freezer compartment door cannot be immediately re-opened after
it has been closed, wait until the resulting low pressure has equalised.
■ The coolant fluid needs time to settle. If the appliance is switched off at any
time, wait 30 minutes before switching back on to allow the coolant fluid to
settle.

6.2 Setting temperature

Testing
1. Clean the freezer with lukewarm water and detergent, and wipe dry.
Note: Electrical components should be cleaned with a dry cloth.
2. Remark: turn the thermostat knob to the "4" position, and plug the freezer into the
wall
outlet. The compressor will begin to run.
3．Check, after 30 minutes of operation, to ensure that the freezer is cold.
Temperature Control
1. The temperature control (thermostat knob，turned by coin) is located near the
top of the unit.
2. Turning the thermostat knob adjusts the temperature of the freezer.
3. The marks on the knob represent different settings. Setting "1" is the
warmest and setting "7" is the coolest，setting "off" is off.
4．The factory recommended setting is "4" for normal operating conditions.
OFZ 10011 A1
EN
Version OK1.0 04/2015 page 11 of 22