Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.
INSTALLATION
Installing/Replacing the lamp
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need an R-7-s pole-burner with up to max. 500 W.
During the operation, the lamp reaches temperatures of up to 900° C.
Procedure:
Step 1: Insert the pole-burner in the housing.
Step 2: Insert the colour-filter frame in front of the lamp.
Rigging
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
The device can be installed on the ground or on the wall or ceiling.
Attachment
Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device without colour-filter frame!
DANGER OF FIRE!
14/34
00025984.DOC, Version 2.1
Werbung
Inhaltsverzeichnis
