Thermostat Operation; In Automatic Mode - Ferroli CRP ZONE Benutzerhandbuch

8.2 Thermostat operation

8.2.1 Manual / Automatic
when the thermostat is in MAnuAl / AuToMATIc mode the display shows the desired temperature set by the user
(A - "fig. 28") and the room temperature (b - "fig. 28").
In case of conditions where the set point is higher (if the system is set for heating) or lower (if the system is set for
cooling) than the room temperature, the thermostat sends the request to CONNeCt CRP. temperature control can
be done manually or automatically.
MAnuAl
In MaNUaL mode ( ) the desired temperature is con-
stant throughout the day / week.
AuToMATIc
[A]

In AuToMATIc mode (

) the desired temperature
varies according to the programmed bands (via aPP or
[B]
CONNeCt CRP).
In any case, it is possible to temporarily change the de-
sired temperature also in aUtOMatIC mode, by press-
ing the buttons . In this mode the ther-
mostat follows the teMPORaRy MaNUaL setting (
) until the end of the current time band, after which
the normal automatic program defined by the user is run.
fig. 28
79
cod. 3542B150 - Rev 00 - 02/2022
EN