Rf Unpairing From Gateway (Unpairing) - Ferroli CRP ZONE Benutzerhandbuch

6.2 RF unpairing from gateway (unpairing)

to unpair the thermostat from the gateway, follow the procedure below.
From CONNECT CRP:
1. Follow the procedure described from point "1" to
point "11" of par. "6.1 RF pairing with gateway
(Pairing)" then continue with point "2" listed below.
2. "LeaVe" appears.
3. Confirm with the button
From CRP ZONE:
4. Press the button b on the thermostat for 1-2 sec.
5. During the pairing phase "LEA" appears on the
thermostat display, with "rF" blinking.
6. If the procedure is successful, the normal use
screen appears for a few seconds, then the room
temperature is displayed with the icon
a new pairing can now be done.
7. If the procedure is not successful, the screen for
normal use returns and it is necessary to repeat the
operation from point 1.
74
EN
.
blinking.
cod. 3542B150 - Rev 00 - 02/2022
R F D E V I C E
L E A V E
I N S T A L L E R
fig. 24
B
fig. 25