Balluff BAV MA-OD-00027-01 Montageanleitung Seite 5

BAV MA-OD-00027-01
Smart Reordering System
Function
The sensor wirelessly transmits distance data via
LoRaWAN to a nearby gateway. This data is usually then
forwarded over a network to a LoRaWAN network server,
where it is processed further. When the sensor is used in
conjunction with the Smart Reordering System, the data is
forwarded to the Smart Reordering application where it is
used for automatic fill level monitoring.
The ToF sensor has a viewing range of 40 to 4000 mm and
an exit angle of 27°. Depending on the distance to the
respective object, this results in a corresponding area (ToF
window) that can be monitored.
Ø = 96 cm
Ø = 29 cm
60 cm
200 cm
300 cm
400 cm
Operating and display elements
Button
Function Operation
Activate sensor from Press the button briefly.
shipping mode.
Set sensor to shipping Press and hold the button until
mode. the yellow and red LEDs light
up simultaneously.
Reset sensor (Reset). Press the button until the
yellow and red LEDs flash.
LEDs
LED Cause – Sensor behavior
Red LED flashes Internal Error – Sensor goes
quickly ten times. into shipping mode.
Red LED flashes slowly Measurement failed – Sensor
five times and then goes into shipping mode.
lights up for five
seconds.
Yellow and red LEDs LoRa Join failed – Sensor tries
flash slowly three times to reconnect to the gateway
simultaneously. first every 4 minutes and then
every hour.
Yellow LED lights up for A distance measurement is
two seconds. performed with subsequent
data transmission via
LoRaWAN.
Yellow LED flashes Data was successfully
three times. transmitted.
www.balluff.com
Ø = 192 cm
Ø = 144 cm
Installation
Two holes are provided for mounting. In addition, a Velcro
strip is included for quick mounting of the sensor.
► Mount the sensor so that the ToF window (see figure) is
positioned directly above or in front of the material to
be monitored.
english 2