OHAUS ACHIEVER e-A51ST020 Bedienungsanleitung Seite 5

Find Quality Products Online at:
EN-4
Set the operating speed range by clicking Gear button (D).
The gear set has its relative LED (C or E) lighted on.
Gear (only for
e-A51ST200)
Gear 1: Low speed (6 400 rpm) High torque (till 200 Ncm).
-
Gear 2: High speed (30 2000 rpm) Low torque (till 40 Ncm).
-
The torque indicator bar (B), made by four LEDs, shows the intensity of
Torque
the torque applied
panel.
Unlock the control panel by holding key H for 3 seconds.
Lock
When the instrument is locked,
- LED (I) lights on for e-A51ST200
- LED (G) and (I) light on for other models
4. Menu
Hold the control knob (F) for 3 seconds to enter into the setting mode when stirring
is off. Turning the control knob (F) it is possible to pass from one of the following
parameters to the next one. Click the knob to modify
Parameter
shown on Default value
display
e-A51ST200
e-A51ST100
e-A51ST060
e-A51ST040
e-A51ST020
GlobalTestSupply
www.
ACHIEVER TM
Range Description
Set starting mode:
Stop: when the
instrument is switched
on through the main
switch, OFF is displayed.
-
Run: when the
instrument is switched
on, it restarts to work
with the last set points.
Set the maximum value of
(1) -
speed set point.
(2) -
-
-
-
-
showed before the number, the
running time is in Day.
To install a new software
version
To restore default setting
-
parameters
To reset torque zero value
-
.com
Overhead Stirrers
sales@GlobalTestSupply.com