Product Features - Peg Perego Pliko Switch On Track Modular Gebrauchsanleitung

stroller when the child is in it.
NAVETTA XL
product characteristics
Navetta XL-auto, Group 0, "Universal"
category
_ The Navetta XL is approved under regulation UN
ECE R44/04 for children weighing from 0-10 kg. It is
suitable for installation on the majority of vehicle
seats, but not all.
_ The Navetta XL can be properly installed if the
vehicle's use and maintenance manual states that
it is compatible with "Universal" Group 0 restraint
systems.
_ The Navetta XL is classified as "Universal" in
compliance with stricter approval criteria than
previous models that do not have this label.
_ The device can only be used on vehicles with
2 or 3 rear seats fitted with 2- or 3-point safety
belts, approved in compliance with UN ECE R16 or
equivalent regulations.
_ For any questions or further information on installing
the Navetta XL in specific vehicles, contact the
manufacturer or the retailer.
IMPORTANT
_ "Navetta XL" (Group 0) must be fitted perpendicular
to the vehicle's normal direction of travel.
_ Do not fit Navetta XL on vehicle seats that face away
or sideways with respect to the normal direction of
travel of the vehicle.
_ The item is given a serial number.
WARNING
IMPORTANT: Read these instructions carefully and
store them in the holder provided throughout the
lifecycle of the product. The child's safety could be
put at risk if these instructions are not followed.
_ It could be dangerous to leave your child unattended.
_ Assembly and preparation of the item must be carried
out by adults.
_ Do not use the product if there are missing or broken
parts.
_ Before use make sure that all of the attachment
mechanisms are connected properly.
_ Do not insert fingers into the mechanisms.
_ Do not use near heat sources, open flames or
dangerous objects that are within reach of the child.
_ It could be dangerous to use accessories which are
not approved by the manufacturer.
_ Make sure the belts fastening the Navetta XL to the
vehicle are always taut and adjust the straps securing
the child.
_ Never twist the belts.
_ Replace the item if it undergoes significant strain
in an accident or shows clear signs of breakage or
deformation.
_ The safety device should not be modified by users in
any circumstances.
_ Carefully follow the instructions supplied by the
manufacturer of the child restraint system.
_ Never leave the child unattended in the Navetta XL in
a vehicle.
_ The Navetta XL must always be secured with the
vehicle's safety belts, even when the child is not
present. In the event of sudden braking, it could
injure the occupants of the vehicle.
_ When travelling in vehicles, never hold the child in
your arms and never put him/her anywhere but in the
Navetta XL. In the event of sudden braking, even at
low speeds, the child would be flung forward.
_ Take particular care to make sure that luggage or
All manuals and user guides at all-guides.com
- 22 -
other objects are not located where they may injure
the child in the Navetta XL in the event of an accident.
_ Do not leave the Navetta XL in vehicles exposed to the
sun. Some parts might heat up and be harmful to the
delicate skin of the child – check before placing the
child in the seat.
_ Make sure that the Navetta XL is not obstructed by
any moving parts of the vehicle's seat or by one of the
doors.
_ Do not use the Navetta XL without its fabric covering,
which cannot be replaced with one not approved by
the manufacturer since it is an integral part of the
Navetta XL and the safety system. If replacing it, use
an official spare part.
_ The design of the Navetta XL features a polystyrene
shock absorption device built directly into the shell,
below the padding: do not remove it.
_ This product is only suitable for children who are
unable to sit up by themselves.
_ This product is designed for children from birth up to
a weight of 9 kg. When used in vehicles it is designed
for weights of up to 10 kg.
_ During use in vehicles, always fasten the safety
harness. When using the product as a carriage,
remove the harness and place it in the special pocket.
_ Only use the product on surfaces that are hard,
horizontal and dry.
_ Do not leave other children playing unattended near
the carriage.
_ Take care when adjusting the mechanisms (handle,
backrest) with the child present.
_ Regularly check the handle (or the handles) and the
bottom of the carriage to make sure that there are no
signs of breakage or damage.
_ When using the carriage with a stand, check the
maximum length of the carriage specified on the
stand.

PRODUCT FEATURES

_ These items are numbered progressively.
_ Pliko Switch On Track Modular is a modular system
characterized by a single cover that can be fitted on
both the Navetta XL and on the Pliko Switch stroller.
_ Pliko Switch On Track Modular consists of: Pliko
Switch chassis, Pliko Switch seat, Navetta XL, Primo
Viaggio Tri Fix car seat, diaper-changing bag.
_ The Pliko Switch stroller has reversible seat: facing the
mother or facing the world.
COMPONENTS OF THE ITEM
Check the contents of the packaging and for any
complaints please contact the After-Sales Service.
_ The Pliko Switch chassis consists of: basket, 2
swiveling or locking front wheels, 2 rear wheels with
brake cable, cup holder.
_ The Pliko Switch seat consists of: hood, front bar, rain
canopy, diaper-changing bag and a cover that can
also be used for the Navetta XL.
_ Navetta XL consists of: hood.
_ Primo Viaggio Tri Fix car seat consists of: hood,
booster cushion, safety harnesses.
INSTRUCTIONS
1 PACKING PROTECTION: before opening the chassis
remove the protection (fig_a), otherwise it will not
open correctly (fig_b).
2 OPENING: raise the two levers together (fig_a) and
pull upwards until the chassis is completely open
(fig_b). Check that the chassis is correctly opened: the
side tubes must be locked together (fig_c).
3 FITTING THE FRONT WHEELS: press the lever of the
two front wheels (fig_a), insert the wheel until it
clicks into place (fig_b) and check that it is securely