Herunterladen Inhalt Inhalt Diese Seite drucken

Dennerle Osmose Professional 190 Bedienungsanleitung Seite 17

Vorschau ausblenden Andere Handbücher für Osmose Professional 190:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
A
11
2
1
5
2 The Osmosis system in summary
Tap adapter 3/4" with supply hose
1
Active carbon filter
2
Fine filter 5μm
3
Membrane container
4
White hose: osmosis water (permeated)
5
Blue hose: residual water (concentrate)
6
3 Mode of use
Remove the two holding clips
at a suitable distance from one another on a wall or board. Please note: Ensure that there is a suitable facility to
allow the water to drain away beneath the osmosis system to enable water to drain away without causing
damage in the event of possible leakages.
Carefully press the osmosis system into the holding clips.
Connect the tap adapter
properly.
Place the residual water hose
Osmose 190 + 380: The flushing valve
Carefully open the tap, to begin with only slightly.
Now check all hose connections and screws carefully to ensure that they are watertight.
(In case of leakages see point 11)
Open tap fully. Allow the system to run for 2 hours in order to rinse away the preservative in the membrane.
During this period, do NOT use the osmosis water, but allow it to drain away. Then open the flushing valve and
rinse the system for 15 min. (see also point 7 – Maintenance).
Your Dennerle Osmosis system is now ready for use. The osmosis water can now be collected and used.
The residual water can also be used, for example for cleaning, watering your houseplants or flushing your toilet.
Recommendation: The osmosis water reservoir should be equipped with a safety overflow to channel the water into
the drain. This will enable you to prevent "flooding" should you forget to turn off the system in time.
10
4
3
7
10
6
from the membrane container and affix them vertically one above the other
10
of the osmosis system to a 3/4" tap (cold water tap!). Ensure that the seal fits
1
and initially also the osmosis water hose
6
must be closed (level at right angles to the flow direction).
9
B
2
11
1
Flow limiter 200cc (Osmose 130) (A)
7
Flow limiter 300cc (Osmose 190) /
8
400cc (Osmose 380) (B)
Flushing valve
9
2 brackets for wall mounting
10
Key for the membrane container lid
11
in the drain.
5
4
3
10
8
9
10
6
5
17

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis