Troubleshooting - Dupray One Plus Bedienungsanleitung

TROUBLESHOOTING

PROBLEM
No steam is released through the hose and
accessories.
Drops of water leak from the attachments.
Dirty water is coming out.
Not enough steam pressure.
Pump is not stopping (humming noise).
Pressure is dropping during operation.
Machine is not heating.
POSSIBLE CAUSE
A. Steam cleaner is not turned on.
B. Water reservoir is empty
C. Unit is not plugged in.
D. Boiler is not fully heated.
E. The hose is not properly connected.
A. Unit is not fully heated.
B. Condensation was created from non-use.
C. O-rings need to be replaced.
A. Scale may have built up.
A. The dial on the handle may be set
too low.
B. Scale may have built up.
A. An air bubble may be in the pump.
B. Water tank is empty.
A. Pressure set to max for too long.
A. Out of water (light may not be on).
B. Steam cleaner is OFF.
REMEDY
A. Follow the instructions on page 10.
B. Add 2.44L (0.64 gal) of water to the reservoir.
C. Plug unit into outlet.
D. Wait for the SteamReady™ indicator (7)
to turn on.
E. Make sure you push the hose all the way in the
connection outlet (3) and insert
the locking pin in place.
A. Wait for the SteamReady™ indicator (7)
to turn on.
B. Let water run through system until steam
comes out.
C. Replace O-rings.
A. Follow maintenance instructions
on page 19.
A. Turn the steam pressure regulator wheel until
the desired pressure is reached.
B. Follow maintenance instructions
on page 19.
A. Press the steam release trigger on the steam
handle. Hold for a few seconds untill the
pump is primed.
B. Put required amount of water into tank.
A. Use lower pressure setting.
A. Follow the instructions on page 10.
B. Turn to setting.