Intended Use - Makita DBO380 Betriebsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Pad size
Abrasive paper size
Orbits per minute
Overall length (with front grip)
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.

Intended use

The tool is intended for the sanding of large surface of
wood, plastic and metal materials as well as painted
surfaces.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-4:
Model DBO380
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
Model DBO381
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
High
Medium
Low
) : 72 dB(A)
pA
) : 72 dB(A)
pA
DBO380
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
DC18SH / DC18WC
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-4:
Model DBO380
Work mode: sanding metal plate
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DBO381
Work mode: sanding metal plate
Vibration emission (a
Uncertainty (K) : 1.5 m/s
9 ENGLISH
DBO381
93 mm x 185 mm
93 mm x 228 mm
-1
12,000 min
-1
8,000 min
-1
4,000 min
336 mm
D.C. 18 V
1.9 - 2.2 kg
2
) : 3.6 m/s
h
2
2
) : 3.6 m/s
h
2