Assembling The Cabin; Assembling The Base Frame; Assembling The Cabin Walls; Mounting The Door - Sentiotec Country Montageanleitung

Assembly instructions

3. Assembling the cabin

ATTENTION!
Note the floor plans on Page 7 and illustrations from Page 10 onwards.

3.1. Assembling the base frame

Place the impregnated base frame on the foundation as shown on the floor plan
and the foundation illustrations (see Page 7).
Make sure that the base frame is assembled at right angles.
Note the power supply!

3.2. Assembling the cabin walls

Always put the wall planks together with the tongue facing upwards.
NEVER hit the tongue directly with a hammer!
Start by laying the half planks of the front and back walls on the base frame and
then put on the two side planks.
Connect the block planks to the concrete foundation at the corners (see 1.3 on
page 4).
Continue row by row - up to and including row 7. Note the position of the ventila-
tion slide in row 2 and the block planks with holes for air inlet/outlet and electrical
installations.

3.3. Mounting the door

Push the door frame into the opening from above (door opens outward).
Install the door fitting.

3.4. Assembling the walls

Assemble the remaining block planks. Continue row by row - up to and including
row 15.
Note the position of the block planks with the holes for wiring.
Prepare the holes for the technical systems (sauna heater, control unit etc.).
Screw the door panel inside at a right angle.
p. 8/10