Ayce DENVER Gebrauchsanweisung Seite 27

Your terrace heater is ready for use!
Warning! Do not connect the terrace heater to the electricity grid if you
notice any damage (whether to the heater, the cable or the plug) and not
before you finished assembling it!
PUTTING INTO OPERATION AND CONTROL
Prior to every usage, check:
• Whether the appliance does not show any signs of
damage.
• Whether the appliance is still assembled firmly.
Wind, rain and gravity could loosen the fastenings in
the long term.
• Whether the socket that you want to use:
• Is earthed.
• Has the correct voltage (220-240V~ 50-60Hz).
• Is located at a safe and dry place.
If everything is in order, you can insert the plug into the
socket and to set the main switch to 'I'.
Operating without remote control
Press on the POWER SETTING to adjust the power to:
• Maximum
• Medium
• Minimum.
After using the terrace heater, set the main switch to 'O' and
remove the plug from the socket.
Operating with remote control
- Insert two AAA 1.5V batteries in the remote control.
- Press on the
- To adjust the power, press on:
Minimum
Medium
Maximum.
- To switch off the terrace heater, press the
main switch to '0' and remove the plug from the socket.
Reset the device and remote control
If the remote control fails to connect with the device, you can reset the terrace heater
and remote control by following the three steps described below:
Step 1: Plug the terrace heater into the mains socket and set the main switch to 'I'.
Step 2: Press and hold the power setting button on the terrace heater until you
hear a 'peep' sound. The receiver in the control box has now been reset.
Step 3: Press the button on the remote control. The device and remote control
are now connected.
Adjusting the heating cap
loosened the adjusting knobs on both sides of the
heating cap, the angle of heating cap can be adjusted
When the heat cap is properly set, make sure that the
adjustment knobs are tightened again.
Warning: The heating cap must always face down.
54 | 55
button to switch on the terrace heater
button, set the
GB