Charging The Battery Pack - IKEA TREDANSEN AA-2320273-2 Bedienungsanleitung

4. Press and hold the pairing button on the remote
for at least 10 seconds.
5. A red LED light will illuminate on the remote. On
your wireless blind, a white LED light will begin
to dim and flash until the devices have been
successfully paired.
Up to 10 wireless blinds can be paired with 1
remote.
Make sure to pair one blind at a time. If you have
difficulties pairing multiple blinds, temporarily
disconnect those that have already been paired by
disconnecting the battery pack inside the blind. This
will help with the pairing process.
Changing the remote's battery
When the remote is used regularly and as intended,
the battery will last for approximately 2 years.
When it's time to replace the battery, a red LED light
will flash when you use the remote.
Open the rear cover and replace the battery with a
new CR2032 battery.
WARNING!
Risk of explosion if battery is replaced by an
incorrect battery type. Dispose of used batteries
according to the instructions.

Charging the battery pack

The included battery pack for wireless blind can be
charged through the signal repeater unit.
Use the included USB cable for charging.
Upon normal use, the battery pack should be
charged every 6 months.
A LED indicator on the battery pack will display the
status.
LED indicator status:
Charging in progress: LED on.
Charging complete: LED off.
Error: LED flashes.
6