IKEA TREDANSEN AA-2320273-2 Bedienungsanleitung Seite 5

Using your wireless blind
To raise blind to top position:
Press the up button once (short press) on the
remote or on the blind.
To lower blind to bottom position:
Press the down button once (short press) on the
remote or on the blind.
To raise the blind:
Press and hold the up button on the remote or on
the blind.
While pressing the button, the blind will rise.
Release the button once the desired height or
maximum height is reached.
To lower the blind:
Press and hold the down button on the remote or
on the blind.
While pressing the button, the blind will lower.
Release the button once the desired height or the
maximum extension is reached.
Setting desired minimum height:
Only the buttons on the blind can be used to set
this level.
Move the blind to the desired height. Afterwards,
short press either the up or down button on
the blind twice to save this position as the new
minimum height.
The blind will move slightly up and down to confirm
the setting.
Resetting minimum height:
To change the minimum height or revert to the
default minimum height setting, first move the
blind to the top position. Afterwards, press either
the up or down button on the blind twice.
The blind will move slightly up and down to confirm
the setting.
Repeat the above steps to set a new desired
minimum height.
Correcting unbalanced blind
If the blind gets stuck when lowering, it might
become unbalanced.
Raise the blind completely to level it again.
Adding devices to your remote
Pairing: Used to add IKEA Home smart products
to your system.
Follow these steps to add more wireless blinds to
your system. Make sure that your wireless blind is
turned on.
1. Open the back cover of the remote and find the
pairing button.
2. Short press both buttons on the blind. This will
wake up the device and it is ready for pairing for
2 minutes.
3. Hold the remote close to the wireless blind you
want to add: no more than 5 cm away from (1).
> 10 s
5