Go/on U55003 Bedienungsanleitung Seite 35

OPERATING INSTRUCTIONS
USED AS AN EMERGENCY POWER STATION ( g.3)
1. Connect the + (red) cable to the positive terminal of your car battery. Then connect the - (black) cable to the engine vehicle
frame. Do not connect the negative clamp to the negative battery terminal! Connecting to the negative battery terminal is an
unsafe practice and increases the possibility of sparking near the batteries explosive gases.
2. Do not allow the RED (POS+) clamp to touch the black (NEG -) clamp.
3. Turn on the power switch of your Power Station, then start your engine. If the engine can't be started, please wait a few seconds
and try again.
4. If your battery is so dead that your ignition light does not come on, let the Power Station stay connected to your battery for 10 –
20 minutes prior to attempting to start your car.
5. Turn off the power switch, disconnect the cables from your car in the reverse order as soon as your car is started.
USED AS A POWER CONVERTER ( g. 4)
To use the Power Station as a power converter, connect booster cable outputs to the positive and negative terminals of your car battery.
The power from the battery is then transferred to the 12V DC output of the Power Station. Thus you can use the power from this
external battery rather than from your Power Station.
(Fig.4)
USED AS POWER SUPPLY FOR 1 12V DC APPLIANCES ( g. 5)
(Fig. 5)
NOTE: do not attempt to jump start your car when you have 12V DC output in use.
(Fig.3)
NEG.
35