Technical Data; General Safety Warnings - Max 56015 Gebrauchsanweisung

MOUSE SANDER
Introduction
To get the most out of your new mouse
sander, please read through these
instructions and the attached safety
instructions before use.
Please also save the instructions in case you
need to refer to them at a later date.

Technical data

Voltage/frequency:
Power rating:
Speed:
Sanding pad:
Incl. dust collector and 10 pc. sandpaper, 80
grit
Sound pressure, L :
pA
Sound level, L :
WA
Vibration:
The table below shows how long you
may be exposed to vibration every day, if
the vibration load of 2.5 m/s
exceeded:
Vibration Max. exposure
2.5 m/s 8 hours
2
3.5 m/s 4 hours
2
5 m/s 2 hours
2
7 m/s 1 hour
2
10 m/s 30 minutes
2
28
220-230 V~ 50 Hz
200 W
13,000 oscillations/min
140×140×98 mm
77 dB(A), K : 3 dB(A)
pA
88 dB(A), K : 3 dB(A)
WA
3.198m/s , K: 1.5 m/s
2
is not to be
2

General safety warnings

Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock,
�re and/or serious injury.
Save all warnings and instructions for
future reference. The term "power tool" in
the warnings refers to your mains operated
(corded) power tool or battery-operated
(cordless) power tool.
Work area safety
• Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
• Do not operate power tools in explosive
atmospheres, such as in the presence of
�ammable liquids, gases or dust. Power
tools create sparks which may ignite the
dust or fumes.
2
• Keep children and bystanders away while
operating a power tool. Distractions can
cause you to lose control.
Electrical safety
• Power tool plugs must match the outlet.
Never modify the plug in any way. Do
not use any adapter plugs with earthed
(grounded) power tools. Unmodi�ed
plugs and matching outlets will reduce
risk of electric shock.
• Avoid body contact with earthed or
grounded surfaces, such as pipes,
radiators, ranges and refrigerators. There
is an increased risk of electric shock if
your body is earthed or grounded.
• Do not expose power tools to rain or wet
conditions. Water entering a power tool
will increase the risk of electric shock.