Safety Instructions; Designated Use; Installation, Commissioning And Operation; Operational Safety - Endress+Hauser Liquiport 2000 Active cooling Betriebsanleitung

Safety instructions

#
22
1

Safety instructions

Safe operation is only guaranteed if these Operating Instructions have been read and the safety in-
structions have been observed.
1.1

Designated use

The active cooling compartment is aimed solely at cooling liquid media in conjunction with the Liq-
uiport 2000. The regeneration unit is used to regenerate the active cooling compartment after a
cooling cycle. The manufacturer does not accept liability for damage caused by improper or non-
designated use. The device can cause danger if used improperly or other than intended. If it is ob-
vious that safe operation is no longer possible (e.g. visible damage), please take the device immedi-
ately out of service. Secure the device against unintentional start-up.
– The active cooling compartment and the regeneration unit may not be used in hazardous areas!
– The manufacturer does not accept liability for damage caused by improper or non-designated use.
The device may not be altered or converted in any manner.
1.2

Installation, commissioning and operation

This device has been constructed to state-of-the-art technology and meets all applicable standards
and EU Directives. However, if the device is used improperly or for anything other than the intend-
ed use, it can present an application-related danger.
The installation, commissioning and maintenance of the device may only be carried out by properly
trained technical personnel. Technical personnel must have read and understood these Operating
Instructions and must adhere to them. The device may only be operated by staff trained to do so.
Warning!
• The device may only be opened by E+H Service! If faults cannot be eliminated, the device must
be taken out of service and protected against unintentional start-up.
• If the housing or housing parts (e.g. control) are damaged, the device must be taken out of service
immediately and protected against unintentional start-up.
1.3

Operational safety

Operation
Warning: hot surfaces at the compartment and the regeneration unit! Only operate on non-flamma-
ble surfaces! Do not store flammable materials in the vicinity of the device! Ensure sufficient venti-
lation is provided! The connection point (socket) must be accessible as a splitter. Only connect to
power sockets with a protective earth contact.
Repairs
Repairs that are not described in these Operating Instructions may only be carried out directly at the
manufacturer's or by the Service department.
EMC
The system meets the general safety requirements of EN 61010-1 and the EMC requirements of
EN 61326.
CE-mark as per European Directives 89/336/EEC (EMC) and 73/237/EEC (Low Voltage Direc-
tive).
Technical improvement
The manufacturer reserves the right to adapt technical details to the most up-to-date technical de-
velopments without any special announcement. Contact your local Sales Centre for information
about the current state of and possible extensions to the Operating Instructions.
Liquiport 2000 Active cooling
Endress+Hauser