Specification - Stadler Form Kettle Six Gebrauchsanweisung

a the end of life do not throw away the kettle, but hand it in at an oficial
collection point for recycling.
over the documents in case you will present this kettle to another person.
Description
lid opening button
lid with a ixation mechanism
nose
Filter
glass pot for water
Blue lighting during boiling
7.
8.
set, storage compartment for the power cord
9. switch
using the appliance
Before irst use
using your kettle
Before using your kettle it is recommended that you clean your kettle before
irst use by illing the kettle with water, up to the maximum level indicator,
boil and discard.
to ill the kettle, remove it from the power base and the lid.
Fill the kettle with the desired amount of water. always ill the kettle
between the minimum and maximum marks. note: do not ill the
kettle over the maximum level, as water may spill out of the spout
when boiling.
touch the Power/Boil button. the button lever will illuminate to in-
dicate the kettle is heating. the kettle will switch off automatically
once the water has boiled. iMportant: ensure that the lid is irmly
in place. note: Boiling can be interupted or cancelled at any time
simply by lifting the kettle from the power base or pressing the but-
ton.
lift the kettle from the power base and pour the water. note: use
caution when pouring the water from your kettle, as boiling water will
scald.
7. the kettle may be stored on the power base while not in use. note:
ensure the power is turned off at the power outlet when the kettle is
not in use.
should you accidentally allow the kettle to operate without water, boil-dry
protection will automatically switch it off. if this occurs, allow the kettle to
cool before illing with cold water and re-boiling.
cord storage Facility
excess cord can be stored by winding up the desired length of cord into the
storage facility inside the power base.
Warning! never switch on the empty kettle!
3-WaY saFetY safety is a major consideration in the design of a stadler
which ensures that your kettle will:
For convenience, safety and energy eficiency, your kettle will automatically
switch off after boiling.
if the kettle is operated without water, it will automatically cut-out, pre-
venting any damage to the element. if this occurs, allow the kettle to cool
before illing with cold water and re-boiling.
in the event of an electrical fault, the kettle will automatically shut down to
prevent further damage. should this occur, take your kettle to a stadler
care anD cleaning
always disconnect the kettle from the power outlet before cleaning.
iMportant: never immerse the kettle switch area and base, cord or po-
wer base in water, or allow moisture to come into contact with these parts.
to use.

speciFication

lid-operating button
Panel light
Power cord storage