Process Of Regulation Parameters Setting - Mandik Rdg160T Bedienungsanleitung

Process of regulation parameters setting

EN
1. Push the left and the right buttons together
for 4 s at least.
2. Release the buttons and immediately
push the right button and keep for about
3 s until P01 is shown instead of the tem-
perature on the display.
3. Turn the wheel to choose the requested
parameter.
4. Push the right button ok
chosen parameter starts blinking, you can
change it by turning the wheel.
24
|
5. Push the right button ok
In order to set further parameters, repeat steps
3 to 5, in order to leave the parameter setting
mode push Esc button
, the value of
set value, using Esc value
the change.
to confirm the
you cancel
.
MMS control box